Extron DA6 RGBHV
6 Output Wideband
Product Highlights
- 1×6 RGBHV Distribution Amplifier
- Video Bandwidth: 350MHz
- Selectable gain and peaking
- Input: One set of female BNC connectors | Output: Six sets of female BNC connectors
- Compatible with RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, and composite video signals
The Extron DA6 RGBHV is a six output, rack-mountable, analog distribution amplifier. It accepts and distributes RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, and composite video on female BNC connectors. In addition, the DA6 RGBHV provides DIP switches for adjusting RGB gain and peaking, as well as for selecting AC or DC coupling. A 9-pin contact closure connector allows for output muting controls when used with a control system.
With 350 MHz (-3 dB) video bandwidth, fully loaded, the DA6 RGBHV is perfect for maintaining signal integrity over long cable runs It includes an internal international power supply and is housed in a 1U, full rack width metal enclosure for mounting convenience.
| Video | |
| Gain | Unity (0 dB) or 1.1 dB (110%), switch-selectable When input = 0.7 V, output = 0.7 V or 0.8 V, respectively. |
| Peaking | |
| DA6 YUV A | 0 dB |
| All other models | 0 dB or +6 dB at 100 MHz, switch-selectable |
| Bandwidth | 350 MHz (-3 dB), fully loaded |
| Differential phase error | <1.0° at 5 MHz |
| Differential gain error | <1.0% at 5 MHz |
| Video input | |
| Number/signal type | 1 RGBHV, RGBS, RGsB, RsGsBs, HDTV component video, S-video, composite video |
| Connectors | 5 female BNC |
| Nominal level (at unity gain) | 1.0 Vp-p for Y of component video and S-video, and for composite video 0.7 Vp-p for RGB, for R-Y and B-Y of component video 0.3 Vp-p for C of S-video |
| Minimum/maximum levels | Analog: 0.3 V to 1.5 Vp-p with no offset at unity gain |
| Impedance | 75 ohms |
| Horizontal frequency | 15 kHz to 180 kHz |
| Vertical frequency | 15 Hz to 170 Hz |
| Return loss | <-38 dB @ 5 MHz |
| DC offset (max. allowable) | 5.0 V (in AC coupling mode) |
| Input coupling | AC/DC, switch-selectable |
| Video output | |
| Number/signal type | 2, 4, or 6 RGBHV, RGBS, RGsB, RsGsBs, HDTV component video, S-video, composite video (follows input type) |
| Connectors | (2, 4, or 6) x 5 female BNC |
| Nominal level | 1.0 Vp-p for Y of component video and S-video, and for composite video 0.7 Vp-p for RGB, for R-Y and B-Y of component video 0.3 Vp-p for C of S-video |
| Minimum/maximum levels | 0.3 Vp-p to 1.5 Vp-p (follows input) |
| Impedance | 75 ohms |
| Return loss | <-44 dB @ 5 MHz |
| DC offset | ±5 mV with input at 0 offset |
| Sync | |
| Input/output type | RGBHV, RGBS, RGsB, RsGsBs, bi-level and tri-level sync |
| Input level | Analog or TTL: 0.5 V to 5 Vp-p |
| Output level | TTL: 5 Vp-p, unterminated |
| Input impedance | 510 ohms |
| Output impedance | 75 ohms |
| Max. input voltage | 5.0 Vp-p |
| Max. propagation delay | 35 ns |
| Max. rise/fall time | 4 ns |
| Polarity | Positive or negative (follows input) |
| Control/remote | |
| Contact closure | 1 female 9-pin D connector |
| Contact closure pin configuration | Pin 1 = mute output #1, pin 2 = mute all outputs, pin 3 = reserved, pin 4 = mute output #2, pin 5 = GND, pin 6 = mute output #3, pin 7 = mute output #4, pin 8 = mute output #5, pin 9 = mute output #6 |
| General | |
| Power | 100 VAC to 240 VAC, 50-60 Hz, 10 watts, internal |
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
| Cooling | Convection, no vents |
| Mounting | |
| Rack mount | |
| DA2 RGBHV | Yes, with optional 1U rack shelf |
| DA4/6 RGBHV | Yes, with included mounting kit |
| Furniture mount | |
| DA4/6 RGBHV | Yes, with included mounting kit |
| Enclosure type | Metal |
| Enclosure dimensions | |
| DA2 RGBHV | 1.7″ H x 8.7″ W x 9.4″ D (1U high, half rack wide) (4.3 cm H x 22.1 cm W x 23.9 cm D) |
| DA4/6 RGBHV | 1.75″ H x 17.5″ W x 8.5″ D (1U high, full rack wide) (4.4 cm H x 44.4 cm W x 21.6 cm D) (Depth excludes connectors.) |
| Product weight | |
| DA2 RGBHV | 2.0 lbs (0.9 kg) |
| DA4 RGBHV | 3.7 lbs (1.7 kg) |
| DA6 RGBHV | 3.9 lbs (1.8 kg) |
| Shipping weight | |
| DA2 RGBHV | 4 lbs (2 kg) |
| DA4/6 RGBHV | 7 lbs (4 kg) |
| Vibration | ISTA 1A in carton (International Safe Transit Association) |
| Regulatory compliance | |
| Safety | CE, c-UL, UL |
| EMI/EMC | CE, C-tick, FCC Class A, ICES, VCCI |
-
HDMI Switcher
-
DVI Switcher
-
VGA Switcher
-
3G/HD/SD Reclocking DA
-
HDMI DA
-
HDMI DA
-
HDMI 1.3 DA
-
1x16 VGA DA
-
1x4 VGA DA
-
1x4 VGA DA
Rent from a Partner, Not a Competitor
24/7 Sales
& Technical support
Same Day Delivery
to Most Major Cities
Competitive
Subrental Pricing
A Large Inventory of
High-Quality Equipment
Best-in-Class
QC Process
Rentex Locations
With locations across the country, Rentex can deliver to most major cities.
To reach local support, simply click on the location below. For Rental Emergency Support, call (866) 541-3465
